HTC Heavy Truss Clips

169a-2015

For alignment control between a roof truss and nonbearing walls; the 2 1/2″ slot permits vertical truss chord movement when loads are applied.

Material: 18 gauge

Finish: Galvanized

Installation:

  • Use all specified fasteners; see General Notes.
  • The HTC has a 2 1/2″ slot to accommodate truss movement.
  • This connector has high lateral capacity.
  • The S/HTC is available for steel truss applications.
  1. Loads may not be increased for short-term loading.
  2. Truss or rafter must be bearing on top plate to achieve the allowable loads under “WITHOUT GAP.”
  3. When installed with maximum 1 1/4″ space between rafter or truss and top plate use loads under “WITH 1 1/4″ GAP.” Where loads are not required, space is not limited to 1 1/4″.
  4. NAILS: 10d = 0.148″ dia. x 3″ long. See other nail sizes and information.
Category: . Tags: , .

About